Your Cart (0)
.jpg){kind=logo}
Thumbnail Filmstrip of EXTEC Labpress® 40 Images
Product Discontinued
The Labpress® 40 is a compact unit with digital instrumentation for clear display of time and temperature. Both of these parameters can be set to give the required automatic molding cycle. The unit requires only single phase electrical power and a water supply. A water inlet and outlet are located on the rear panel.
The Labpress® 40 features a compact lightweight design, integral hydraulic pressurizing system, interchangeable mold sizes in inch and metric diameters, quick and easy mold change.
The hydraulic pressurizing system is contained in the metal cabinet. It comprises a compact hydraulic pump and controller which applies pressure to a mold through an intermediate cylinder. The cylinder acts as an amplification stage so that pressure applied to the mold is adequate to mold all currently used compression mounting materials. A control valve is fitted below the front control panel and can be adjusted for molding a particular resin.
The Labpress® 40 can be configured with 1"; 1 ¼"; 1 ½"; 25mm; 30mm; and 40mm mold assemblies.
Cap holding top piston, locks with bayonet fitting, sealing mold.
Hydraulic Pressure Unit:
Compact Hydraulic Pump and Controller to Adjust Pressure; (in bar) Intermediate cylinder moving lower piston out of mold. Pressure Safety Valve
Molding Pressure:
Up to 6000 psi (Mold 1.25")
Heater Block:
Incorporates 4/250 W Heater Cartridges with fuses for Overtemperature Protection.
Temperature Controller:
Temperature can be set up to 250° C or 480° F; K Type Thermocouple
Timer:
Digital Timer can be set to count down, 0-60 minutes.
Cooling:
Cooling water channels in heater block connected to supply through a solenoid water switch.
Dimensions:
Width: 14" (355mm)
Depth: 16" (400mm)
Height: 15" (380mm)
Weight:
66 lbs. (30 kg)
