Your Cart (0)
.jpg){kind=logo}
Thumbnail Filmstrip of EXTEC Labpro® 1 Images
- Meter and dispense any two component epoxy, urethane, or silicone
- Pull the handle and dispense only as much as you need, exactly with precise mix ratio
- Eliminates hand weighing
- Improves quality control by eliminating guesswork and human error out of process
- Economical allows purchasing material in bulk rather then expensive cartridges
- Wide mix ratio from 1:1 to 100:5
- Easy adjust mix ratio with our patented slider scale
- Heated tank option available for thick materials and cold factories
- Compact bench top size
- Robust industrial design
- No minimum viscosity, maximum viscosity (around 50,000 cps) basically any pourable or self-leveling liquid.
- Also some thicker materials and pastes can be used, consult factory.
- Minimum shot approximately 6-8 cc. (Depending on ratio)
- Maximum shot approximately 60cc (approximately 32cc per piston on full stroke)
- Dispense infinite amount by using multiple strokes.
- Up to 10 shots/minute.
- Average approximately 4-6 shots/minute.
- This depends on material viscosity, shot size, and operator experience.
- Manual lever pull system
- Plus or minus 1% to 5%
- Highly Accurate Positive displacement pump.
- 2 Quart (1.89 liters) each resin and hardener tanks standard.
- External 1 to 16 Gallons (3.79 to 60.6 liters) gallon tanks option. Heaters are available.
- Some filled materials can be used, consult factory.
- Heated tank option available. Keeps material in tanks at constant 120°F (49°C).
- Manual operation, no air or electric needed.
- For heater option 115 VAC at 5 amps or 220 VAC at 2.5 amps required.
- Base footprint
- Width: 12 inch (305mm)
- Length: 12.5 inch (318mm)
- Height: 8 inch (203mm)
- Weight: 18 lbs (8.17 kg)
- Approvals: CE, RoHS, WEEE
